Dremel 670 Mini Saw Attachment Reviews

• Not new, but useful

  
  By AAFHVE189CRTD on 2003-09-11
  Dremel had a saw blade bit an number of years ago but withdrew it, probably because there was no blade guard. Now they have solved the blade guard problem and by angling the tool a bit have made it able to cut in the center of a board. It took a little getting used to before I got comfortable with it because the guard tends to fight you a bit until you develop the technique to open it properly as you start the cut. It is limited to 1/4" depth of cut making it specifically a modelers tool. When used for what it does best, it is great.
  
  

• Poor quality.

  
  By on 2003-05-23
  It works fine but it rattles like it is going to fall apart. Very poor construction built like dremel has abought 2 dollars in construction. All plastic except for center shaft. They should charge a price closer to the quality of product abought $5.00 Here is to a vibrating piece of junk.
  
  

• Awesome little saw

  
  By on 2004-01-09
  I am amazed at the clean cut that this saw makes. I suppose it depends on the material you are cutting, but more often than not get a smooth, precise cut with no ragged edges. The saw is also remarkably easy to guide and cut a straight line. It's very well put together and I've had no negative issues with it whatsoever.
  
  

• Works great for small jobs! Could use some improvements.

  
  By A1LS6OQJIJ9VGB on 2006-04-06
  Fine for cutting thin wood or plastic. I wish it cut deeper - say up to 1/2 inch. Also wish there was a way to manually move the blade protector out of the way while cutting.
  
  

• Works OK - barely...

  
  By A2T456JKRMMWEP on 2007-01-31
  I bought this to trim some 1/4" plywood from underneath a cabinet (couldn't get a chisel in there) and it worked just OK. To cut about a 1 foot section took about 10 minutes with a ton of burning and smoking of the blade and grinding to a halt (absolutely no torque) when met with a bit of resistance. It might work ok for balsa wood, but for anything else it is too weak a blade (carbide tipped would be better). Also, the blade guard is annoying because you can't get flush up to your edge (leaves about 1/8" or so of wood still along the joint). It's also annoying how you have to change out the head unit of your dremel, making it time consuming to switch back to normal collet and bits.
  
  

• This Old House (1-year)
• Building Construction Illustrated

• Dremel 546-01 1-1/4-Inch Diameter Rip/Crosscut Blade
• Dremel 575 Right Angle Attachment
• Dremel 220-01 Rotary Tool Work Station
• Dremel 400-6/90 Variable Speed XPR Rotary Tool Kit With 90 Accessories
• Dremel 231 Shaper/Router Table